The White Rodgers F145RF-1328 is a wireless remote indoor sensor designed for use with compatible White Rodgers Comfort-Set thermostats (e.g., 1F95 series). It allows for remote temperature sensing in different rooms, providing averaged or selected readings for improved comfort control. Features battery operation (2 AA batteries), transmission range up to 200 ft, and easy pairing. Below are the key specifications, installation, operation, and troubleshooting instructions.
Assemble tools: screwdriver (for battery compartment), double-sided tape or screws for mounting. Ensure compatible thermostat (e.g., 1F95 series with remote sensor capability). Install 2 AA alkaline batteries. Place sensor away from drafts, direct sunlight, heat sources, or obstructions for accurate sensing and reliable transmission.
WARNING! Failure to read and follow all instructions carefully before installing or operating this sensor could cause improper operation. Save these instructions.
The F145RF-1328 is a wireless remote indoor sensor that transmits temperature data to the thermostat, enabling multi-room sensing. It supports up to 3 sensors per thermostat, with averaging or individual selection options. The sensor is battery-powered and communicates via RF signal, providing accurate local temperature readings for better system control.
Applications: Compatible with White Rodgers Comfort-Set thermostats supporting remote sensors; indoor use only.
CAUTION! Do not immerse sensor in water or expose to excessive moisture. Avoid extreme temperatures. Ensure clear line-of-sight or minimal obstructions between sensor and thermostat for reliable RF transmission.
WARNING! Batteries may contain hazardous materials; dispose properly. Do not disassemble or modify sensor.
Remove battery tab. Mount sensor on wall using double-sided tape or screws (hole in back). Place within 200 ft of thermostat, avoiding metal obstructions. No wiring required.
Enter thermostat menu to add sensor (refer to thermostat manual). Press sensor button to transmit ID. Thermostat confirms pairing. Up to 3 sensors supported.
No wiring; wireless RF communication.
Verify transmission LED blinks on button press. Thermostat displays sensor reading. Test by moving sensor to different temperature area.
Not applicable; sensor only.
Sensor provides temp data for thermostat control; no direct operation.
Not applicable.
Sensor provides temp data for thermostat control; no direct operation.
No direct programming; pair via thermostat menu. Sensor ID auto-assigned.
Configure sensor averaging/selection in thermostat installer menu.
| Symptom | Possible Cause | Corrective Action |
|---|---|---|
| No Transmission | Low battery, out of range. | Replace batteries; reposition sensor. |
| Inaccurate Reading | Improper placement. | Relocate away from heat sources/drafts. |
| LED Not Blinking | Battery dead. | Replace 2 AA batteries. |
| Thermostat Not Seeing Sensor | Unpaired, interference. | Re-pair; reduce obstructions. |